Exterior Retail Sample Model

Exterior Retail Sample Model

This Exterior Retail Sample Model was provided by Mesh 3D as a sample for new IRender nXt users.

Download the model from the 3D Warehouse

Model rendered with IRender nXt for 150 passes. Rendering time 2 hours


Nighttime Scene

Nighttime Scene

The image above was rendered with a twilight effect.

There are two post-processing changes you can make dynamically (without re-rendering) to switch from a daytime scene to a nighttime scene. The Brightness Control and Lighting Channels

The "Twilight" scene already has some lighting channels applied - as you will see below.

Default Settings

Retail sample daylight.jpg

This is the same model rendered with default settings.

In normal daylight, the sun and sky are really too bright to see the interior light and street lights.

Using the Brightness Control

Retail sample 45.jpg

There is a Brightness Control at the top of the rendering window which should be your first tool to adjust brightness.

Here we lowered it from 50 (default) to 40. It made the sky and scene much darker, but also made the lights themselves darker.

Turn off the Sky

Retail sample no-sky.jpg

We will see the lights much better if there is no sky at all.

I could turn off the sky, and re-render. Our we could use a Post Processing feature, Lighting Channels to turn off the sky.

The Lighting Channels Wizard is loaded from an icon above the rendering area.

Here I turned off the sky, using Lighting Channels, so I could see the effect immediately (without having to re-render the model)

Lighting Channels - no sky.jpg

Lower the Sky and increase the Lights.

Retail sample 40-40.jpg

Turning off the Sky was probably too drastic, so instead we can turn it back on, but not as bright.

The twilight model above was created with the Sky turned on, but set very low (0.01). To make the Sky even darker, and create more of a nighttime scene, you can use Lighting Channels to lower the sky even more, or raise the lights. (Either one has the same effect).

For the image at the left, I left the sky at 0.01, but raised the street lights and ceiling lights from 1 to 40.


Using both Brightness and Lighting Channels

Retail sample 20-20-45.jpg

I felt that the image above had both the sky and the lights too bright, so I decided to use the Brightness Control as well. I lowered the lights from 40 to 20, (for better bakance between sky and lighting), and then lowered the brightness from 50 to 45.

This is all done immediately, without having to re-render, so it is very easy to use these controls to get just the effect you want.

Blurry Reflection

Blurry Reflection

This model has defined blurry reflection for the concrete areas. This effect - done by lowering the Sharpness of the reflection material provides a realistic, wet concrete effect to the rendering. However, the way this is achieved - by changing the angle of the reflection for each rendering pass will require more rendering passes than renderings with sharper reflections.

Results after 1 pass

Ret 1 lower left.jpg

Here is the rendering of the concrete are after just one pass.

The reflections are very sharp - because just one sample has been taken from the reflection of the lights.

Results after 3 passes

Ret 3 lower left.jpg

After 3 passes, you can see how it works - each light has 3 reflections - but it creates a very unrealistic effect until you allow for many more samples.

It will need more passes to converge properly.

Results after 150 passes

Ret 150 lower left.jpg

This image was allowed to render for 150 passes. It is almost acceptable now, especially if the reflections were in more subtle parts of the drawing.

This would be a good model to let render overnight to really let things converge.

See also

Sample Models and Renderings